67Pinnacle Systems TARGA 3000
Set Adobe Premiere TARGA Settings
Once all the Project Settings have been made, you need to set how the TARGA 3000
compresses and controls images. This is done by way of the TARGA Settings dialog
window. A detailed explanation of this panel and the selections that can be made in it can
be found in “Chapter 2: TARGA Specific Control Panels Within Adobe Premiere.”
—From capture settings within the “New Project Settings” dialog window, click on the
SETTINGS button. The TARGA Settings dialog window will be displayed.
—Click on the CAPTURE tab. The TARGA Settings Capture window will be displayed.
—From the pull-down within the selection, select the input you have connected to the
TARGA 3000 card. Your choices should be either Pro Analog Breakout Box
(assuming you have a Pro Analog Breakout Box connected) or 1394.
—From the pull-down within the “Video Format” section, you can select the
compression CODEC you want to use. Your options are (refer to Chapter 2 for
detailed information about the choices here) :
• DV 25
• YUV 4:2:2
For the purposes of this tutorial, select YUV 4:2:2.