Quantum Scalar i6000 - Chapter 5 Advanced Reporting

Chapter 3: Configuring Your Library
Configuring Screen Saver Preferences
Quantum Scalar i6000 User’s Guide 249
•Select Custom to change screen saver settings such as
activation, movement, or images.
•Select Off to disable the screen saver. (The current settings are
cleared.)
If you selected Custom, go to Step 3. Otherwise, go to Step 6.
3 Under Activation, enter a value in the Wait box to specify how
much idle time must pass before the screen saver is activated.
The activation wait time can be 1 – 120 minutes.
4 Under Movement, specify the position and the motion of the
screen saver image on the screen.
•Select Random to display the screen saver image in a variety of
positions.
•Select Stationary to display a static screen saver image that
does not move.
•Select Linear to display the screen saver image as a floating
image.
• Enter values in the horizontal and vertical boxes to specify the
movement of the screen saver image in pixels.
• Enter a value in the Motion Delay box to specify the movement
speed of the screen saver image.
5 Under Images, specify the image files to display for normal
functions, warning notices, and failure notices. You must select
image files for all three functions.
• To specify an image file, click Browse. Select the image file and
then click Open. The image file must be in GIF, JPEG, or PNG
format, and cannot be larger than 1 MB. In addition, image
resolution is limited to 600 x 800 pixels.
•Click Preview to preview an image file.
6 Click OK to save the settings and close the Preferences dialog box.
Or click Apply to save the settings without closing the Preferences
dialog box.
7 Because you made system configuration changes, you are prompted
to save the configuration changes. For more information, see
Saving
and Restoring Library Configuration on page 601.