Quantum Scalar i6000 - Page 351

Chapter 9: Extended Data Lifecycle Management
Configuring EDLM
Quantum Scalar i6000 User’s Guide 333
This section describes how to create, modify, and remove EDLM policies
on partitions.
Note: Cartridges that are not capable of being read by at least one of
the tape drives in the EDLM library managed partition are
excluded from all scans. (For example, if the EDLM library
managed partition contains only LTO-5 tape drives, then LTO-1
and LTO-2 cartridges will not be scanned.)
1 Select Setup > Partitions > Policies > EDLM Configuration. The
Extended Data Life Management Configuration Wizard appears.
2 Click Next. The Select the EDLM Configuration Option screen
appears. All of the library’s partitions are displayed in a table. The
EDLM Policy column indicates whether EDLM policies are enabled
or disabled on the partition.
Media Scan Candidate
Policies
Specifies when to perform automatic scans
on media in the partition. See
Step 5 on
page 336.
Media Scan Type
Policies
Specifies which type of automatic scans to
perform (quick, normal, or full). See
Step 7
on page 339.
Media Scan Results
Action Policies
Specifies what actions to take on suspect or
failed media. These policies apply to all
media in the partition, whether they were
scanned manually or automatically. See
Step 11 on page 341.