Chapter 9: Extended Data Lifecycle Management
Configuring EDLM
334 Quantum Scalar i6000 User’s Guide
3 Create, modify, or remove policies on a partition by doing one of
the following:
To. . . Do this...
Enable EDLM policies on a
partition
1 Select the Enable radio button.
2 Select the check box of a partition in the table that has EDLM
policies disabled.
3 Proceed to Step 4.
Modify existing EDLM policies
on a partition
1 Select the Modify radio button.
2 Select the check box of a partition in the table that has EDLM
policies enabled.
3 Proceed to Step 4.