Chapter 15: Maintaining Your Library
Monitoring the Library
Quantum Scalar i6000 User’s Guide 543
Tab l e 49 on page 543 describes the elements on the Partitions
Status dialog box.
Table 49 Partition Status
Element Description
Name The name of the partition.
Status The status of the partition (Online or Offline).
Media Type The type of media used in the partition (LTO-1, LTO-2, LTO-3, LTO-4, LTO-5,
LTO-6 or LTO-7).
Interface The type of interface used to connect to the host (FC).
#Drives The number of tapes drives in the partition.
#Storage Slots The number of storage slots in the partition.
#I/E Slots The number of I/E station slots in the partition.
Media Type Checking The current setting for media type checking (Required, Not Required, or
Disabled).
Media Identifier The current setting for return media identifier (Suffix, Pass Through, Prefix,
or Disabled).
Drive Autolevel The current setting for drive firmware autoleveling (Enabled or Disabled).
Auto Drive Clean The current setting for automatic drive cleaning (Enabled or Disabled) as
well as the number of motion hours set for each drive cleaning.
Encryption Defines the encryption method for the partition. The values are Not
Supported, Application Managed, or Library Managed. If the partition is
enabled for FIPS, “FIPS” appears in parentheses.
LCP WWPN The Library Control Path (LCP) World Wide Port Name (WWPN) for a
partition. A WWPN will only be listed if control path or control path
failover is used to present the partition to the SAN.
Library Type Logical library/partition type - either Standard or Library Managed. If
library managed, the type of library managed partition is listed in
parentheses (for example, AMP, EDLM, or VAULT).
To Next Page
Loading...
Need help?
General
