Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
4.13.4 ACCESSING THE SQEL FUNCTION ON THE FRONT PANEL
DISPLAY
To access the SQEL function, proceed as follows:
1. Use the GROUP switch to display the SQEL group.
2. Press down on the SET/NEXT switch to display PRSQ or POSQ as required. The PRSQ and
POSQ functions, each has an additional menu layer beneath them containing seventeen settings
consisting of DISA and sixteen timer settings ranging from 0ms to 9.3ms as listed above.
3. When the display shows PRSQ or POSQ, the green part of the ON/OFF indicator lights when
the function is selected.
4. Press up once on the SET/NEXT switch.
The display will now show “DISA”, which is the first available setting.
5. Press down on the SET/NEXT switch additional times to see the other available timer settings.
As the timer settings are being displayed, the green part of the ON/OFF indicator lights when
the display shows the currently-set timer setting, and the red part lights when the display shows
any other timer setting.
6. To change the current timer setting, press down on the SET/NEXT switch until the display
shows the desired timer setting, and then press up twice on the SET/NEXT switch
After the first press, the green part of the ON/OFF indicator flashes, meaning that
a change is about to be made. After the second press, the green part lights
continuously, showing that the timer setting has been changed to the displayed
value.
M-DACS-T1 RFL Electronics Inc.
July 18, 2008 4-21 (973) 334-3100
To Next Page
Loading...