RFL Electronics IMUX 2000 - Figure 5-35. Page 1 of Typical Complete Network Information Report

Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
M-DACS-T1 RFL Electronics Inc.
Report Name
Complete Listing
NetList
Page 1
Date/Time 03/20/02 10:09:25
Date and Time 01/11/01 15:59:04 01/11/01 16:01:04
CSU Perf. – ANSI Local <no/none>
CSU Perf. – ANSI Remote
<no/none>
AT&T Performance Report
<no/none>
Framing (ESF or SF) FRAMING = ESF
T1 Code (AMI or B8ZS) CODE = B8ZS
Primary Timing Mode LOOP LOOP
T1 Line Loopback OFF OFF
T1 Payload Loopback OFF OFF
T1 Equipment Loopback OFF OFF
Fast Reframing ON ON
Clear Channel Card Config.
OFF OFF
Clear DACS Config. OFF OFF
Clear ILS Config. OFF OFF
Local SNMP Trap ON ON
Remote SNMP Trap ON ON
Force Main ON or OFF ON ON
Redundant Switch Control
AUTO AUTO
CSU Mode Control RFL RFL
Reset CSU OFF OFF
Report Alert at Stby OFF OFF
Pre-Squelch Timer (ms) DISA DISA
Post-Squelch Timer (ms) DISA DISA
Shelf is Normal SHELF NORMAL
Fallback timing FTIME= INT (FALLBACK TIMING)
Payload loopback status <no/none>
Line loopback status <no/none>
Equipment loopback status
<no/none>
Curr rcv blue alarm cnt 0
Curr rcv yellow alarm cnt 0
Network Name Demo T1 network
Author’s Name Frank Luo
Comment * Created by Auto Cfg
Create Date 3/19/02 11:59:07
Last Saved 03/20/02 10:09:15
Figure 5-35. Page 1 of typical Complete Network Information Report
Term 1 1 R - AutoCfg Net Address1
TERM CM4 New Common Logic module
Type Address Node DACS ILS CM4-1 CM4-2 Channel Card/Description Set To Actual
February 28, 2006 5-53 (973) 334-3100