Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
4.14.1 SELECTING THE INTF GROUP
To select the INTF group, press up or down on the GROUP switch one or more times until "INTF"
appears in the display. At this point each time the SET/NEXT switch is pressed down, the next INTF
function will be displayed. The three functions in the INTF group are:
1. Type
2. Head
3. TLBO
Each of these three functions each has an additional menu layer beneath them containing more
functions, and may be thought of as subgroups within the INTF function group.
4.14.2 SETTING THE SYSTEM TYPE
There are two available TYPE settings, T1 and E1. To display and change the system TYPE, proceed
as follows:
1. Use the GROUP switch to display the INTF group.
2. Press down on the SET/NEXT switch to display TYPE.
3. Press up once on the SET/NEXT switch.
The display will now show "E1" which is the first available TYPE setting.
4. Press down on the SET/NEXT switch one more time to see the next TYPE setting, which is T1.
As the TYPE settings are being displayed, the green part of the ON/OFF
indicator lights when the display shows the currently-set TYPE, and the red
part lights when the display shows the other TYPE.
5. To change the current TYPE setting, press down on the SET/NEXT switch until the display
shows the desired TYPE, and then press up twice on the SET/NEXT switch.
After the first press, the green part of the ON/OFF indicator flashes; this means
that a change is about to be made. After the second press, the green part lights
continuously; this means that the TYPE is now set to the displayed value.
The last function in the TYPE subgroup is exit. When the exit function is displayed, you can press up
on the SET/NEXT switch to leave the TYPE subgroup and display HEAD, the next INTF function. To
exit the INTF group entirely, press up or down on the GROUP switch.
M-DACS-T1 RFL Electronics Inc.
July 18, 2008 4-23 (973) 334-3100
To Next Page
Loading...