Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
15. Events Causes the Sequence Of Events buffer to be read by the Network
Management Software and allows the user to view or print the Sequence
Of Events buffer.
16. Terminal Causes the software to enter Terminal Emulation mode. Refer to Section
8 on Remote Configuration for more information.
17. Real Time Allows a user to change the configuration parameters of any card in the
network in real time which means that any change that is made will be
written to the network immediately. Real time mode is used when you
have only a few (1 or 2) changes to make in the network.
18. Batch Allows a user to change the configuration parameters of all nodes in the
network or of just one node in the network in one operation. The change
does not take place immediately. The user must select either a network
write or an individual node write in order to implement the change.
(NOTE: Batch is the default mode. The red dot indicates which mode is
selected)
M-DACS-T1 RFL Electronics Inc.
February 28, 2006 5-12 (973) 334-3100
To Next Page
Loading...