Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL DS-562NC RFL Electronics Inc.
July 5, 2012 42 (973)
334-3100
IMUX 2000 DS-562NC AND RFL 9700A (RS-449, RS-530)
Interfacing an IMUX 2000 DS-562NC with an RFL 9700A can be accomplished as follows:
A. Configuration of RFL 9700A:
97A DIG RX: J2: “B” Position
97A DIG TX: J2: “B” Position
B. The configuration of the IMUX 2000 RS-449 Channel Card shall be as follows:
1. DS-562NC with MA-406IA I/O
MA-406IA I/O: J2 jumpers in DCE mode
J3 in any position
DS-562NC, Switch SW6-5 (Receive Clock Polarity): Normal - OFF (DOWN)
DS-562NC, Switch SW6-7 (Transmit Clock Polarity): Normal - OFF (DOWN)
C. Confirm Clock and Data Transitions to Insure Proper System Operation as follows:
1. RFL 97A DIG RX: The positive edge of the RxClock (TP2) must be in the center of the
RxData bit (TP1).
2. IMUX 2000: DS-562NC - The positive edge of the TxClock (TP16) must be in the
center of the TxData bit (TP15).
To Next Page
Loading...