Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL OCUDP RFL Electronics Inc.
July 15, 2010 2 (973) 334-3100
SPECIFICATIONS
As of the date this Instruction Data Sheet was published, the following specifications apply to the RFL
OCUDP module. Because all of RFL products undergo constant improvement and refinement, these
specifications are subject to change without notice.
Operational:
ANSI T1.410 Metallic interface
AT&T TR62310 DS0 digital local channel interface
Bellcore TA-TSY-000077 Dataport channel unit functions
Baud rate 56 kbps user rate and
64 kbps clear-channel user rate.
OCUDP Channel Loopback Responds to code from CO to reverse loop current thereby
56 kbps ONLY causing customer equipment to loopback signal to OCUDP.
Latching loopbacks supported only.
OCU Loopback Responds to code from CO to loop 4 wire circuit back to CO
56 kbps ONLY on output of OCUDP. Latching loopbacks supported only.
OCU Cable Loss Up to 45 dB
Interface connector RJ-48S
Environmental:
ANSI C37.90 – 1989 Service conditions
Operating Temperature -20
o
C to +55
o
C
Storage Temperature -40
o
C to +75
o
C
Humidity 95% at 40
o
C, non-condensing
SWC/Fast Transient:
ANSI C37.90 – 1989 Dielectric
ANSI C37.90.1 – 1989 SWC and fast transient
RFI Susceptibility:
ANSI C37.90.2 – 35 V/M
System Performance:
Power consumption 2 watts nominal
MTBF >500,000 hours at 25
o
C
To Next Page
Loading...