Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL OCUDP RFL Electronics Inc.
July 15, 2010 12 (973)
334-3100
h. Turn Module Service on, either through the remote control P4 parameter or through the
Network Management System.
The RFL OCUDP’s operating parameters can now be changed by remote control. See
Remote Control Interface section of this Instruction Data Sheet for more information.
i. Go to step 16.
16. On the Module Record Card located to the right of the shelf, record the channel bank type, time
slot, and any other pertinent information.
The RFL OCUDP is now installed. If your multiplexer is set up for remote access and control, you can
now change the operating parameters of the module by using simple commands. For more information
on remote access and control, consult your multiplexer operation manual.
To Next Page
Loading...