Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Chapter 5 - Use of the SETUP Menu
SNMP Access Gateway User’s Manual - v1.0 -- 11/99 - Page 13
Chapter 5 - Use of the SETUP Menu
Upon
selecting ‘Enter Command Mode’ from the main SNMP Access Gateway menu, the password prompt as
shown below is presented for entry of the Command Mode Password.
Command Processor Password: ----
Command Password Accepted
Upon entry of a valid password the Command Mode Prompt (a ‘greater than’ sign) is shown and commands can be
entered. The first time the command prompt is presented, an additional line is printed (as shown below) to remind
the user of a few basic commands and this prompt can be redisplayed by pressing ENTER on a blank line of the
command prompt. The SETUP command presents the user with a menu of basic setup functions.
>SETUP
Setup Main Menu
A. Networking
B.
Serial/Input Ports
C. Passwords
D. Event Definitions
E. Action Definitions
F. System Date/Time
G. Other Settings
Selection?
Ma
ny of the above menu items have extensive sub-menus for configuration of all the possible SNMP Access
Gateway settings. The following sections take each of the above menu items and go through the possible options and
selections.
5.1 - Networking
Selecting the Menu Letter of NETWORKING from the Setup Main Menu presents the following submenu for setting
various network related options. The Networking menu appears as follows. Each of the menu items shown below is
discussed in order in this section.
Setup: Networking
A. Network Access Enabled [Y]
B.
Get IP Address via [BOOTP/DHCP]
C. IP Address [192.168.100.131]
D. Network Mask [255.255.255.0]
E. Default Router [192.168.100.254]
F. FTP AutoDelete [N]
G. SNMP Manager Setup
H. SNMP Trap Setup
I. SNMP Community Setup
J. IP Address Restrictions
K. Ping Router every 10 Mins [N]
L. PPP Dialout Setup
M. PPP Hosting Setup
5.1.1 - Network Access Enabled
This option is toggled by pressing its Menu Letter. The default for this option is Y but communication via the
ethernet interface can be inhibited by disabling this selection.
5.1.2 - Get IP Address
This option is toggled by pressing its Menu Letter. The default selection is BOOTP/DHCP and the alternate
selection is STATIC. The default selection has the SNMP Access Gateway request and respond to BOOTP/DCHP
To Next Page
Loading...