Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Chapter 5 - Use of the SETUP Menu
SNMP Access Gateway User’s Manual - v1.0 -- 11/99 - Page 20
Pag
er Message - In the case of an Alphanumeric pager this entry contains an optional text message which is included
in the pager message whenever an alarm is sent to this pager. In the case of a numeric pager, this is the number
which is transmitted as the message to the numeric pager.
Pager Type (A-Alpha, N-Numeric) - This selection indicates whether the protocol used for this pager should be
numeric (numbers only, keyed in by touch-tones) or TAP protocol for sending alphanumeric messages.
Repeat Until Source Acked - This option indicates whether paging should repeat at intervals until the SNMP Access
Gateway is specifically connected to and the alarm acknowledged.
Time (minutes) Between Repeats - This value indicates the duration between repeats mentioned above.
Transmit UnitID - This option selects whether the Unit ID should be included in the pager message transmitted. This
only applies to alphanumeric pagers.
Transmit Reason for Action - This option selects whether a condensed code indicating the reason for the pager alarm
should be transmitted as part of the alarm message. This only applies to alphanumeric pagers.
Numeric Pager Dial Delay - This value sets the number of seconds between the initial modem dialing of the numeric
pager phone number and the subsequent dialing of the pager ID number.
Numeric Pager Hang-up Delay - This value indicates how long the SNMP Access Gateway waits after sending the
final digits to the numeric pager before the SNMP Access Gateway disconnects.
5.6 - System Date/Time
Selecting the Menu Letter of SYSTEM DATE/TIME from the Setup Main Menu presents the following prompts for
entry of the date/time information to set the SNMP Access Gateway internal clock.
Setup System Date/Time
MON 04/06/98 17:58:22
Time (24-Hour HH:MM) [17:58]?
Date (MM/DD/YY) [04/06/98]?
Day of Week (1-7, 1=SUN - 7=SAT) [2]?
Adjust for Daylight Savings? [Y]?
MON 04/06/98 17:58:00
5.7 - General Settings
Selecting the Menu Letter of GENERAL SETTINGS from the Setup Main Menu presents the following submenu for
setting a number of miscellaneous operational settings of the SNMP Access Gateway.
Setup: General Settings
A. Set UnitID
B. Operational Settings
C. Misc. Modem-Related Settings
D. Character Mask
Selection?
5.7.1 - Set UnitID
By pressing the Menu Letter of this option a prompt is presented for entry of the Unit ID.
UnitID [SNMP Access Gateway]?
To Next Page
Loading...