Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Chapter 9 - SNMP Configuration and Control
SNMP Access Gateway User’s Manual - v1.0 -- 11/99 - Page 31
snmpSendTestTrap When this object is set to any value, then the
SNMP Access Gateway sends a ‘test’ trap by sending
a trap to all of the managers in the
snmpManagerTable. This test trap may be used to
assure that the proper SNMP managers are set up in
the smpManagerTable, and that each manager is
properly responding to traps.
9.6 - ftpsetup
ftpAutoDelete This object controls the auto deletion of the
events log file when it is retrieved by FTP. When
set to 0, the file is not automatically deleted.
When set to 1, the events file entries which were
retrieved by FTP are automatically deleted from
the events log file as the data is retrieved by
FTP.
9.7 - events The events section of the MIB is used to control
which events are stored in the events log file,
provide status information on the configuration of
the data alarms, enable the processing of data
alarms, retrieve and set the sensor alarm
configuration.
storeDataEvents This object, when set to 1, allows all data
records received on the serial I/O ports to be
stored as events. This object can be enabled to
store all data records in the events log file.
The storage of all data records which are received
would be most useful when each data record
received by the SNMP Access Gateway is an alarm
record, a no data alarm processing is performed by
the SNMP Access Gateway.
storeAlarmEvents This object, when set to 1, allows all data alarm
records to be stored in the events log file. A
received data record is determined to be a data
alarm record if the alarm evaluator determines
that the data record matches any of the defined
alarm criteria, regardless of the count of such
data alarm records received.
storeResetEvents This object, when set to 1, allows all resets from
any source to be stored as events in the events
log file. This may be useful in detecting power
outages which might affect the operation of the
SNMP Access Gateway or other equipment.
storeCommandLog This object, when set to 1, allows all command
lines entered at the command processor to be
stored in the events log file. This allows a
system administrator to examine the usage of the
commands.
storeSensorEvents This object, when set to 1, allows all sensor
activation and in-activation events to be stored
in the events log.
alarmEvaluator This object enables and disables the alarm
evaluator. When set to 0, no alarm evaluation is
performed on data records, so no data alarm
records are stored in the events file, and no data
alarms are activated. When set to 1, the alarm
evaluator is used to detect data alarm records and
sense when data alarm events must be performed.
dataAlarmTable This table provides retrievable information on the
status and configuration of the data alarms. The
data alarms are configured using an alarms
configuration file, so objects in the
dataAlarmTable are read-only. The number of table
entries provided is equal to the number of defined
data alarms in the alarms configuration file.
dataAlarmActive This object shows that a particular data alarm is
active. This object always reads as 1
To Next Page
Loading...