BIT SWITCHES
B620 30 B620
System Switch 1F SP No. 1-101-032
No FUNCTION COMMENTS
0 Not used Do not change the setting.
1
Report printout after an original
jam during SAF storage or if
the SAF memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to “1” if the customer does not want
to have a report in these cases.
Memory TX – Memory storage report
Parallel memory TX – Transmission result report
2 Not used Do not change the setting.
3
Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately after
the machine receives it.
1: The machine prints the complete message after
the machine receives all the pages in the memory.
4-6 Not used Do not change the factory settings.
7
Action when a fax SC has
occurred
0: Automatic reset
1: Fax unit stops
0: When the fax unit detects a fax SC code other
than SC1201, the fax unit automatically resets itself.
1: When the fax unit detects any fax SC code, the
fax unit stops.
Cross Reference
Fax SC codes - See “Troubleshooting”
Memory File Transfer Operation Procedure
SP No 1-101-005
System Switch 04 Bit 5
Procedure
1. Enter service mode and change this bit to 0.
2. Exit the service mode.
3. Enter the key-operator mode, and select ‘Key-operator settings’.
4. Choose ‘03’ and specify a destination for the machine to transfer all the files to.
5. Press ‘Start’.
6. After the machine transfers the memory files, enter the service mode and reset
this bit to 1.
NOTE: Anybody who knows how to enter the key-operator mode can transfer
confidential messages.
⇒
Rev.09/2005
To Next Page
Loading...
