B622 10 SM
4.2.2 AUTO CONTINUE
When this function is enabled, the machine stops printing and cancels the print job
if there is no paper tray which matches the paper size and paper type specified by
the driver.
If Auto Continue is enabled, the machine waits for a specified period (0, 1, 5, 10, 15
minutes) for the correct size paper to be set in the tray, then cancels the print job if
the interval expires.
• The interval can set with the Printer Settings in the user tools.
(User Tools/ Printer Settings/ System/ Auto Continue)
If Auto Continue is disabled, the machine will not print the job, but will not cancel it,
so the job stays in the print queue.
The default setting for Auto Continue is “Off.”
Auto Continue OFF
Immediately
1 minute
5 minute
10 minute
15 minute
Job stays in the printer
Job is immediately canceled
Job is canceled after 1 minute
If no paper tray matches the paper size and paper type specified by the driver:
and so on
B622D908.WMF
To Next Page
Loading...
