Ricoh B121 - Printer Service Mode; Bit Switch Programming; Service Mode Table

PRINTER SERVICE MODE
B622 4 SM
3.2 PRINTER SERVICE MODE
3.2.1 SERVICE MODE TABLE
SP No. Description Function and Setting
1001 BitSw#1 Set Adjusts bit switch settings.
Note: Currently the bit switches are not being used.
1003 Clear Setting Not used
1004 Print Summary
Prints the service summary sheet
(An error log is printed in addition to the configuration
page).
1005 Display Version Displays the version of the controller firmware.
3.2.2 BIT SWITCH PROGRAMMING
1. Enter the SP mode, select “Service Menu”, then press
[Enter] twice.
2. Select #1, #2, #3, or #4 for the desired bit switch, then
press [Enter].
• [▲] [▼]: Move to the next switch.
3. Adjust the bit switch using the following keys.
• [▲] [▼]: Move to the next bit.
• [Escape]: Exit without saving changes.
• [Enter]: Exit and save changes.
The left digit on the display is bit 7 and the right digit is bit 0.
4. Press [Enter] to save changes and exit.
Bit Switch 1
Bit Switch 01 - Not used (do not change any of these settings)
Bit Switch 2
Bit Switch 02
No Description Function
0-2
Not used Do not change the setting.
3
PDL Sniffing PDL Sniffing with Multiple PDLs
0: Enabled (default)
1: Disabled
4-7
Not used Do not change the setting.
Service Menu
BitSW
BitSW
<BitSW#1>
Sw#1 00000000
Bit0 _