Ricoh B121 - By-Pass Tray

EXTERIOR COVERS & OPERATION PANEL
SM 3-9 B121 Series/B259 Series
Replacement
Adjustment
3.3.10 BY-PASS TRAY
1. Right rear cover ( 3.3.8)
2. Open the right door ( 3.3.9).
3. Release the by-pass tray cable from the clamps (see [C] on the preceding
page) and disconnect the connector (5-pin connector with colored wires).
4. Cable holder [A] (B123 only)
5. Front-side clip ring [B]
6. Front-side pin [C]
NOTE: You can push the pin from behind the right door.
7. Front-side tray holder arm [D]
8. Remove the rear-side clip ring, pin, and tray holder arm in the same manner.
9. By-pass tray [E]
B121R907.WMF
B121R948.WMF
[D]
[B]
[E]
[C]
[A]