404 Rockwell Automation Publication 193-UM015D-EN-P - February 2015
Chapter 9 EtherNet/IP Communications
ATTENTION: If an Upload command is not successful when manually adding
an E300 Electronic Overload Relay, failure to cancel the new module addition
process will result in the loss of any preconfigured E300 Electronic Overload
Relay configuration data. Default values will be used when the RSLogix 5000 or
Studio 5000 project is downloaded to the Logix controller or when adding an
E300 Electronic Overload Relay online to a ControlLogix project.
To Next Page
Loading...
