Sel 421 - Page 6

iv
SEL-421 Relay Date Code 20090715
Table of Contents
Section 4: Communications Interfaces
Communications Interfaces..........................................................................................................................R.4.1
Serial Communication..................................................................................................................................R.4.2
Communications Card ..................................................................................................................................R.4.4
Section 5: SEL Communications Protocols
Serial Port Hardware Protocol......................................................................................................................R.5.1
Software Protocol Selections........................................................................................................................R.5.2
Protocol Active When Setting PROTO := SEL............................................................................................R.5.3
Virtual File Interface...................................................................................................................................R.5.11
SEL M
IRRORED BITS Communications......................................................................................................R.5.15
SEL Distributed Port Switch Protocol (LMD) ...........................................................................................R.5.21
SEL-2600A RTD Module Operation..........................................................................................................R.5.23
Section 6: DNP3 Communications
Introduction to DNP3 ...................................................................................................................................R.6.1
DNP3 in the SEL-421...................................................................................................................................R.6.5
DNP3 Documentation ................................................................................................................................R.6.12
Application Example..................................................................................................................................R.6.27
DNP LAN/WAN.........................................................................................................................................R.6.32
DNP LAN/WAN in the SEL-421 ...............................................................................................................R.6.32
DNP LAN/WAN Documentation ...............................................................................................................R.6.41
DNP LAN/WAN Application Example......................................................................................................R.6.49
Section 7: Synchrophasors
Introduction ..................................................................................................................................................R.7.1
Synchrophasor Measurement .......................................................................................................................R.7.6
Settings for Synchrophasors .........................................................................................................................R.7.9
Synchrophasor Relay Word Bits.................................................................................................................R.7.19
Synchrophasor Analog Quantities..............................................................................................................R.7.20
View Synchrophasors by Using the MET PM Command..........................................................................R.7.24
C37.118 Synchrophasor Protocol...............................................................................................................R.7.25
SEL Fast Message Synchrophasor Protocol...............................................................................................R.7.31
Synchrophasor Protocols and SEL Fast Operate Commands.....................................................................R.7.37
Section 8: IEC 61850 Communications
Features.........................................................................................................................................................R.8.1
Introduction to IEC 61850............................................................................................................................R.8.2
IEC 61850 Operation....................................................................................................................................R.8.3
IEC 61850 Configuration ...........................................................................................................................R.8.12
Logical Nodes.............................................................................................................................................R.8.16
Protocol Implementation Conformance Statement: SEL-400 Series Devices ...........................................R.8.31
ACSI Conformance Statements..................................................................................................................R.8.37
Section 9: ASCII Command Reference
Description of Commands............................................................................................................................R.9.2
Section 10: Settings
Alias Settings..............................................................................................................................................R.10.3
Global Settings ...........................................................................................................................................R.10.4
Breaker Monitor Settings .........................................................................................................................R.10.11
Group Settings..........................................................................................................................................R.10.14
Protection Free-Form SEL
OGIC Control Equations .................................................................................R.10.34
Automation Free-Form SEL
OGIC Control Equations...............................................................................R.10.35
Output Settings .........................................................................................................................................R.10.35
Front-Panel Settings .................................................................................................................................R.10.37
Report Settings .........................................................................................................................................R.10.44
Port Settings..............................................................................................................................................R.10.46
DNP3 Settings—Serial Port .....................................................................................................................R.10.50
Courtesy of NationalSwitchgear.com