sennebogen 830 E - Page 266

Operation - Work application
6 - 80
830 / 07.2012
Original operating instructions
DANGER
 Danger to life!
Risk of accident as a result of suspended loads!
If the magnet system fails, the load will fall.
Always lower the load when work is interrupted.
Never leave the driver's cab when a load is suspended.
 Activate the overload warning device and check that it is operating
properly.
 During operation, dangerous voltages can occur.
 Inserting or removing plugged connections during operation is not
permitted.
 Assembly/start-up of the generator as well as maintenance and
service work on the magnet unit are to be performed only by
authorized and qualified specialists.
 Before using the magnet unit, read the manual.
 Use permitted accessories only. For more information, please
contact SENNEBOGEN Customer Service.
 Operation is only allowed with magnetic plates: other applications
are unauthorized.
 Observe operating data.
 Cleaning with a high-pressure washer (steam cleaner) is not allowed.
 The openings for the condensation vent must be at the lowest point.
 Observe further safety guidelines.
 No alterations may be made to the generator (e.g. location, drive type).
CAUTION
 If the magnet unit is not switched off after use, the entire system
(generator and magnetic plate) can overheat.
 The generator must not be used in potentially-explosive environments!
 Never switch on the magnetic plate unless it is required for the work
being performed. Material can be unintentionally pulled into an
activated magnetic plate suspended in the air.
 Neither the system itself nor the individual system components may be
modified. Any modification, incorrect repair or use of inappropriate
third-party parts will invalidate any warranty claims. SENNEBOGEN
Maschinenfabrik GmbH accepts no liability in this instance.
 Never expose the components of the generator system to high-
pressure cleaning jets. Danger of destruction!