Operation - Work application
6 - 81
830 / 07.2012
Original operating instructions
WARNING
Ensure that the permitted load limits are not exceeded.
1 Start the engine in accordance with Section 4.10.4.
2 Set the RPM adjustment (6) on the right rear control panel to
maximum.
3 Set the magnet according to the load material.
4 Switching on the magnet unit:
– Actuate the switch on the upper right control panel.
The following symbols appear in SenCon:
– Press the front pushbutton (4) on the right-hand control
lever.
The following symbols appear in SenCon:
To Next Page
Loading...