08/2005 Expanding the Operator Interface (BE1)
5 Configuring OP Hotkeys and PLC Keys
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
BE1/5-135
5.5.3 Program operating area
State Function
10 File selection
20 Program handling
70 Log
5.5.4 Services operating area
State Function
10 Data in
20 Data out
90 Series machine startup
60 Setting data
80 Interface
40 Manage data
100 Upgrading
5.5.5 Diagnosis operating area
The main screen in the Diagnosis operating area is the alarm overview.
The following horizontal softkeys can be used to access other states from this state:
State Function
10 Alarms
20 Messages
30 Alarm log
40 Service displays
50 PLC status
Messages, alarm log and service displays can always be accessed.
5.5.6 Start-up operating area
The main screen in the Start-up operating area is an overview of the available NC
axes and drives.
State Function
0 NC axes and drives
10 Machine data
40 PLC status
50 drive/servo
60 HMI
5.5.7 Custom operating area
See Chapter 6.
To Next Page
Loading...
Need help?
General
