Starting Up HMI Embedded (IM2) 08/2005
8 Diagnostics
© Siemens AG, 2005. All rights reserved
IM2/8-122 SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
If the bit is already set when HMI Embedded is booted, HMI Embedded does not
respond to the value of the bit (only after it has been reset and set again).
• The log file _AC_LOGP.TXT is read out either during the boot process or can
be read out in the Diagnosis operating area until the system is next switched
off. The file is then deleted.
• Reboot of the control with
• Prompt: "Action log detected! Read out CF-Card? ([Y]/N)"
• Acknowledge with “Yes”; the log file is now saved on the CF card.
Note
A latency must be observed between two signals to make sure that the second
signal can be processed.
8.2 Software version display
Function
The version data of the installed system software are output
in the version display.
Procedure
• Select the "Diagnostics" operating area
• Select the "Service displays" softkey
• Select the "Version" softkey
You can display the version data of the following areas via the horizontal softkeys:
• Version data of the NCU
• Version data of the HMI
• Version data of the cycles (user, manufacturer, standard cycles)
• Definitions
• Compile cycles
■
To Next Page
Loading...
Need help?
General
