EasyManuals Logo

Siemens SINUMERIK 840D Commissioning Manual

Siemens SINUMERIK 840D
626 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #290 background imageLoading...
Page #290 background image
Starting Up HMI Embedded (IM2) 08/2005
4 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM2/4-40 SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
4.2.7 Geometry processor
You have two possibilities of specifying the text output at the end of a contour and
to set the representation of the contour elements:
1. Via the HMI user interface
2. Via the display machine data MD 9460: PROGRAM_SETTINGS
Settings from the HMI user interface
Press the "Contour settings" vertical softkey.
The window pane: "Free contour programming settings" will be opened:
- Enter after "Text output at the end of the contour programming" the text that is
to appear after each contour, e.g. "Contour end"
You can select/deselect other settings:
- Technology specifications: "Rotate"
- Show graphically softkey for geometry elements
Settings in the display machine data
The following section describes the settings in the display machine data as used in
HMI Embedded:
Bit 0
= 1 Technology rotating (contour support)
Bit 3
= 0 The softkeys for selecting the contour elements are assigned
text.
= 1 The softkeys for selecting the contour elements are assigned
icons.
4.2.8 File manager
You can use the file manager to select a connection as standard directory for all
created drives.
You can specify the selection of this standard directory using a display machine
data or via the HMI user interface:
1. Via the display machine data MD 9005: PRG_DEFAULT_DIR:
You can use the Select key to select all created drive connections (1 to
max. 8).
2. From the HMI user interface:
Click the "Settings" vertical softkey and the "Program overview" vertical
softkey. All created drives will be shown. The Select key is used to select a
connection to be used as standard directory; it is saved with the "OK"
softkey.

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals