EasyManuals Logo

Siemens SINUMERIK 840D Commissioning Manual

Siemens SINUMERIK 840D
626 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #470 background imageLoading...
Page #470 background image
Commissioning HMI Advanced (IM4) 08/2005
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM4/2-76 SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
2.4.13 Configuring the "EXIT" Softkey
Application
If you want the sequence control of the HMI software to support an “EXIT” softkey,
you should make the following settings:
[Miscellaneous]
ExitButton=True
ExitButtonIndex = index
The text for identifying the softkey text must be entered in
F:\mmc2\language\re_xx.ini where xx is the language identifier.
ExitButtonAccessLevel=7 ; Dialog box to ask user
ExitButtonQueryUser = True
Requesting a RESTART after shutdown (for Windows XP only)
This function enables HMI Advanced (including Windows XP) to be shut down
followed by a reboot of the PCU during the setup phase. This enables you to avoid
switching the PCU or machine on and off.
The following settings are required:
[Miscellaneous]
EnableRebootDialog=True
The entry can be set either directly in the INI file or by means of the user interface
via Start-up HMI Settings HMI Exit Mode. If the “EXIT” menu is configured
accordingly, the “Shutdown... " or "Restart ... " prompt appears depending on the
access stage.
If the protection level is lower than the manufacturer level (protection level 2
to 7) or if the above entry is set to "False" in the REGIE.INI file, the prompt
can be confirmed with:
OK HMI is closed and Windows XP is shutdown.
Cancel HMI is not closed
If you have the applicable access authorizations (protection level 2 to 7), the
following option is offered:
Restart HMI and Windows XP are closed and then
restarted.
Exit HMI is closed and Windows XP is shutdown.
Cancel HMI is not closed

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals