08/2005 Starting Up HMI Embedded (IM2)
4 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
IM2/4-39
4.2.6 Setting the editor
The editor is available in the "Program" and "Startup" operating areas.
You can set the editor settings as follows:
1. Via the display machine data MD 9460: PROGRAM_SETTINGS
2. Via the HMI user interface
Settings in the display machine data
The following section describes the settings as used in HMI Embedded:
Bit 2
= 0 No automatic enabling for programs
= 1
Automatic enabling for programs created using the "New"
softkey.
Bit 4
= 0 Line feed will be displayed in an opened file in the edit field.
= 1 The LF (line feed) icon will be hidden in an opened file in the
edit field.
Bit 5
= 0 Hidden lines marked with "*HD" (hidden) will be displayed.
= 1 Hidden lines marked with "*HD" (hidden) remain hidden.
Bit 6
= 0 Active program disabled for editing.
= 1 Active program enabled for editing.
Bit 7
= 0 Perform line test
= 1 Disable the line test of the cycle support for programs with a file
size in the MD 9464 display machine data greater than:
MAX_PROGRAMM_SIZE_CHECK. The size is entered in
KBytes. New lines can also be added within the G-Code
created by the "Wizard" or the geometry processor.
The settings in the Program/Startup operating areas are retained after a reset.
Settings via the HMI user interface
From the HMI user interface, you can make the same settings in the "Editor
settings" window pane as for the display machine data.
Open a program for editing in the "Program" operating area.
To obtain the settings window, press the "Settings" horizontal softkey and the
"Editor Settings" vertical softkey.
You can mark the following functions in the "Yes" field at the side.
- Release new programs
- Hide LF in the program
- Display hidden lines in the program
- Enable active programs for editing.
- Special handling for mold making File size in KB
To Next Page
Loading...
Need help?
General
