08/2005 Commissioning HMI Advanced (IM4)
2 Setting Functions and Parameters
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IM4/2-41
2.2.8 Representation of Spindle Utilization
Function
Up to now, the display range of the spindle utilization in the Machine main screen
was represented at 100%. You can set the display range of the bar graph for
representation of the spindle load to 200% using display MD
$MM_MA_SPIND_POWER_RANGE.
9428
MD number
$MM_MA_SPIND_MAX_POWER
Maximum value of the spindle performance display
Default setting: 100 Minimum input limit: 100 Max. input value: ****
Changes effective after: Power ON Protection level: 3/4 Unit: %
Data type: WORD Applies from version 6.4
Meaning In this MD, enter the factor by which the supplied spindle utilization will
be multiplied.
9429
MD number
$MM_MA_SPIND_POWER_RANGE
Display range for spindle utilization
Default setting: 100 Minimum input limit: 100 Max. input value: ****
Changes effective after: Power ON Protection level: 3/4 Unit: %
Data type: WORD Applies from version 6.4
Meaning In this MD, you specify the display range of the bar graph for the spindle
utilization display. Depending on the value entered, the percentage
values displayed and the extent of the color areas change.
Value 100: Percentage values 0%, 80%, and 100% are displayed. The
color display changes from green to red starting at 80% if a value of 100
is also set in display MD 9428.
Value > 100, e.g., 200: Percentage values 0%, 100%, and 200% are
displayed. The color display changes from green to red starting at 100%.
If you set the value to 200%, you must enter the normalization factor in
display MD $MM_MA_SPIND_MAX_POWER.
To Next Page
Loading...
Need help?
General
