Starting Up HMI Embedded (IM2) 08/2005
4 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM2/4-50 SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
4.9 Workpiece templates
Workpiece templates for a program can be used for similar programs.
For that purpose, you must create a workpiece with the name _TEMPL_. If you
press the "New" softkey, this workpiece is copied and renamed. All files in this
directory are also copied into the new directory.
Example:
Suppose you want to create a workpiece template with the content "Daten.ini" and
"TEST.MPF":
Workpiece: _TEMPL_
_TEMPL_.MPF
DATEN.INI
TEST.MPF
Operating sequence:
1. Press the "New" softkey
2. Name: Define "ACHSE"
3. The new workpiece "ACHSE" is created with the following files:
ACHSE.MPF
DATEN.INI
TEST.MPF
4.10 Analog spindles
The spindle load from 0 to 100% can be displayed in the spindle window for up to
two analog spindles. For that, the following bytes must be set in DB 19:
Analog spindle: DB19.DBB 6
Analog spindle: DB19.DBB 7
References: /BEM/ Operator's Guide HMI Embedded
To Next Page
Loading...
Need help?
General
