08/2005 Starting Up HMI Embedded (IM2)
4 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
IM2/4-57
4.13.3 Milling simulation 3D graphic
This function is a software option named “Milling Simulation”, with order number
6FC5253-0AE02-0AA0.
If the option is set, the “3D Simulation” softkey will appear and can be used to
select the function.
Operation of milling machine simulation is described in:
References: /BEM/ Operator's Guide HMI Embedded
4.14 Measuring cycle support in the G code editor
In HMI Embedded you can integrate screen forms, which provide for programming
measuring cycles, into the G code editor. These cycles can then be recompiled
automatically.
The "measuring cycles" function is a software option with order no.
6FC520-0BX00-0AB0.
For further information about measuring cycle support, please refer to:
References: /BNM/ User's Guide Measuring Cycles
• In the ANWENDER-ZYKLEN\COMMON.COM file, remove the semicolon ";" in
front of the following lines:
;SC326 = AEDITOR.COM ;Turning measuring cycles (horizontal softkey 6 on
;the extended softkey bar in the G code editor)
;SC327 = AEDITOR.COM ;Milling measuring cycles (horizontal softkey 7 on
;the extended softkey bar in the G code editor)
In this way, you establish the connection between the softkeys, with which you
call the measuring cycle support, and the configuration file of these support
screens.
• In the ANWENDER-ZYKLEN\COMMON.COM file, remove the semicolon ";" in
front of the following line:
;SC617 = STARTUP.COM ;Startup operating area (horizontal
;softkey 7 on the extended softkey bar
;in the G code editor)
In this way, you can change the properties of the measuring cycle support in
the “Startup” operating area.
Change the properties of the measuring cycle support in the "Startup" " >"
"Measuring Cycles" menu.