EasyManuals Logo

Siemens SINUMERIK 840D Commissioning Manual

Siemens SINUMERIK 840D
626 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
Expanding the OperatorInterface (BE1) 08/2005
6 Custom Operating Area
© Siemens AG, 2005. All rights reserved
BE1/6-150 SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
These softkeys are configured in file custom.com (like the standard version of
aeditor.com supplied) as described below.
In HMI Embedded, references must be made in file common.com (access file on
the NC for Expand user interface) to custom.com for the customer start softkeys.
Common.com is supplied so that all CUSTOM operating area softkeys are linked to
custom.com.
6.3 Response to operating area changeover
When you change from the CUSTOM operating area to another operating area and
back again, the window, which was active when you closed the CUSTOM
operating area, reappears the next time you open it.
îš„

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals