Expanding the Operator Interface (BE1) 08/2005
3 Syntax
© Siemens AG, 2005. All rights reserved
BE1/3-76 SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
3.5.8 Methods for start softkeys
Start softkeys are softkeys that are not called from a form screen, but which have
been configured before the first new screen form. These functions are configured
using the following method:
PRESS method
The PRESS method is executed when the corresponding softkey is pressed.
PRESS(identifier)
...
END_PRESS
where:
IdentifierName of softkey: HS1-HS8, VS1-VS8
or RECALL
HS1 = ("other softkey menu")
HS2 = ("no function")
PRESS (HS1)
LS("Menu1") ;Load a new softkey menu
END_PRESS
PRESS (HS2) ;Empty PRESS method
END_PRESS
3.6 Function
A variety of functions are available in screen forms and screen-form-dependent
softkey menus. These can be activated by specific events (exit input field, actuate
softkey) and configured in methods.
3.6.1 Screen form or softkey change
LM function
The LM function can be used to load another screen form.
LM("Identifier"[,"File"] [,MSx [, VARx] ] )
where:
IdentifierName of the screen form to be loaded
File Path name (HMI file system or NC file system) of the configuration
file, default setting: Current configuration file
MSx Screen form change mode
0: The current screen form is discarded, the new screen form is loaded
and displayed. On EXIT (see EXIT function) you will be rerouted to
the standard application. You can use the MSx parameter to
determine whether or not the current screen form should be
terminated when changing screen forms. If the current screen form is
retained, variables can be transferred to the new screen form.
To Next Page
Loading...
Need help?
General
