08/2005 Expanding the Operator Interface (BE1)
7 Configuring and Working Environment
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
BE1/7-163
Operating area
SCxxx Screen form:
SC8454 Program-Miscellaneous
operating area
Vertical SK 4
SC857 Messages/Alarms operating
area
Horizontal SK 7
SC858 Messages/Alarms operating
area
Horizontal SK 8
SC867 Tools/Zero offsets operating
area
Horizontal SK 7
SC8493 Program-G-Code-Editor
operating area
Horizontal SK 3
(drilling cycles
support) *
SC8494 Program-G-Code-Editor
operating area
Horizontal SK 4
(milling cycles
support) *
SC8495 Program-G-Code-Editor
operating area
Horizontal SK 5
(turning cycles
support) *
* This involves Siemens screen forms.
Start hotkeys for HT6
The start hotkeys named here can be used to activate the associated configuration
files.
The possible start hotkeys for screen forms are pre-defined. No additional start
hotkeys can be configured. Access points are specific to operating areas.
HCyyy=File
HCyyy hotkey connection (connecting the hotkey with the configuration file). yyy
stands for one of the internal hotkey identities listed below for the start hotkeys; file
is the name of the configuration file identities for start hotkeys:
HCyyy Key:
HC1 User key U1
HC2 User key U2
HC3 User key U3
HC4 User key U4
HC5 User key U5
HC6 User key U6
HC7 User key U7
HC8 User key U8
HC11 Special key S1
HC12 Special key S2
HC21 TEACH key
To Next Page
Loading...
Need help?
General
