08/2005 Online Help (HE1)
1 Programming Help
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
HE1/1-11
Excerpt from txt file "IFM_GR.COM":
...
a2//G00/Linear interpolation with rapid traverse (m) Short Help
a2//G01/Linear interpolation with feed (m)
...
a/20/"PGA.PDF",2,"="/=/Assignment operator with Long Help
...
a/3/"PG.PDF",17,"ANG"/ANG/Contour angle (s) with Long Help for
... cycles
m/14/"PGZ.PDF",302,"CYCLE77"/CYCLE77/Circular spigot milling
cycle with Long Help for
... cycles
CONTEXT section
An increased context sensitivity of the Help function can be selected in the
[CONTEXT] section. This setting is activated with "1" and deactivated with "0".
(Also parameterized under "Settings").
If the increased context sensitivity is activated and the cursor is positioned to the
left of or on an instruction text, then all instructions with the same initial letters are
displayed when Help is called.
For example, if the programmer has selected instruction "G1", then all instructions
beginning with "G1" (e.g. "G1", "G17", "G18", "G19") are displayed.
If increased context sensitivity has been deactivated with "0", then only the
instruction actually selected (if available) is displayed.
TEXTSEARCH section
The text search type can be specified in the [TEXTSEARCH] section. The following
search methods can be parameterized:
1 = instruction texts only
2 = descriptive texts only
3 = instruction and descriptive texts
(also entered under "Search").
To Next Page
Loading...
Need help?
General
