08/2005 Starting Up HMI Embedded (IM2)
5 Creating In-House Alarm Texts
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
IM2/5-103
5.5 Bitmaps and icons
5.5.1 Storage of bitmaps and icons
Bitmaps and icons are stored in the folders below, depending on their resolution
and the operator panel being used:
Storage folder Formats Resolution OP (operator panel)
ico640 *.ico, *.png, *.bmp 640 x 480 OP10
ico800 *.ico, *.png, *.bmp 800 x 600 OP12
ico1024 *.ico, *.png, *.bmp 1024 x 768 OP15
The images are stored on the CompactFlash card under various paths, divided into
write-protected (standard) and user-specific areas.
Standard (write-protected)
The write-protected standard icons are stored in folders (icoxxx) using the following
path:
"/siemens/sinumerik/hmi/ico/icoxxx/"
xxx stands for the relevant resolution, "640", "800", "1024" (see table above).
User
The user-specific icons are stored in folders (icoxxx) in the following three
subdirectories:
• Standard expansion
(AddOn projects), /addon/sinumerik/hmi/ico/icoxxx
• Manufacturer, /oem/sinumerik/hmi/ico/icoxxx
• User /user/sinumerik/hmi/ico/icoxxx
In-house configurations
Files with the configured screen definition "Expanding the user interface" (wizard
"com files" including icons) are located in folders:
/oem/sinumerik/hmi/proj
/user/sinumerik/hmi/proj
See submanual: IAM, BE1: Expanding the user interface
5.5.2 User status display
Machine states controlled by the PLC can be displayed in the program status bar
via user icons.
The user-icon display has to be activated via display MD 9052
SHOW_CHANNEL_SPANNING_STATE.
The program path of the currently selected program is then displayed in the bar
underneath, together with the program name.
16 display positions are defined in the program status bar.
To Next Page
Loading...
Need help?
General
