Commissioning HMI Advanced (IM4) 08/2005
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM4/2-116 SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
;
;LINK=TC_DPC7
;
; MD 18096: $MN_MM_NUM_CC_TOA_PARAM=7
; MD 18097: $MN_MM_TYPE_CC_TOA_PARAM[7]=4
; MD 18080: $MN_MM_TOOL_MANAGEMENT_MASK='H4'
;
LINK=0 ; example LINK=TC_DPCS1
; example data sets
[500.1] ; unique identifier (t,d) for roughing tool 1
tool_type=500 ; tool type, if not set, $TC_DP1 is
; used
insert_length= ; TC_DP8, insert length
holder_angle= ; TC_DP10, holder angle
reference_direction= ; TC_DP11, cutting direction
clearance_angle= ; TC_DP24, clearance angle
[500.2] ; unique identifier (t,d) for finishing tool 1
tool_type=510 ; tool type, if not set, $TC_DP1 is
; used
insert_length= ; TC_DP8, insert length
holder_angle= ; TC_DP10, holder angle
reference_direction= ; TC_DP11, cutting direction
clearance_angle= ; TC_DP24, clearance angle
[520.1] ; unique identifier (t,d) for plunging tool 1
tool_type=520 ; tool type, if not set, $TC_DP1 is
; used
insert_length= ; TC_DP8, insert length
reference_direction= ; TC_DP11, cutting direction
[530.1] ; unique identifier (t,d) for parting tool 1
tool_type=530 ; tool type, if not set, $TC_DP1 is
; used
insert_length= ; TC_DP8, insert length
reference_direction= ; TC_DP11, cutting direction
[540.1] ; unique identifier (t,d) for thread-cutting tool 1
tool_type=540 ; tool type, if not set, $TC_DP1 is
; used
reference_direction= ; TC_DP11, cutting direction
[160.1] ; unique identifier (t,d) for boring-threading-
; milling cutter
tool_type=160 ; tool type, if not set, $TC_DP1 is
; used
tip_angle= ; TC_DP10, tip angle
;TC_DPV3= ; 1=+X; -1=-X
;TC_DPV4= ; 1=+Y; -1=-Y
;TC_DPV5= ; 1=+Z; -1=-Z
To Next Page
Loading...
Need help?
General
