Customer Replaceable Units Exterior Panels and Access Doors
Page 187
© Copyright 2021 Stratasys. All rights reserved.
Installing the Upper Side Panels Left/Right
1. Gently insert the locating tab on the bottom of the upper side panel into the slot at the top of
the lower side panel. See Figure 25.
2. While aligning the upper side panel with its mounts, use a 3 mm hex wrench to loosely
install the upper side panel mounting screws (3).
3. Tighten the upper side panel mounting screws (3). See Figure 25.
4. Close the top access door.
To Next Page
