Customer Replaceable Units Camera
Page 227
© Copyright 2021 Stratasys. All rights reserved.
Installing the Camera
1. Connect the camera cable to the connector inside the cutout in the oven frame above the
oven enclosure entrance.
2. Insert the camera into the cutout and align it with its mounts inside the oven frame.
3. From inside the oven, use a 3 mm hex wrench to install the screws (2) that secure the
camera inside the oven frame. See Figure 58.
4. Using a 3 mm hex wrench, install the screws (2) that secure the camera cover plate to the
bottom of the oven frame above the oven enclosure entrance. Support the plate to prevent
it from falling. See Figure 59.
5. Close the oven door.
To Next Page
