• SV 110 vibration calibrator
• SC 50Z car cigarette plug to external power supply plug
• SC 39P LEMO 4-pins (plug) to 3 x BNC sockets cable (0.7 m)
• SV 50 set for Hand-Arm measurements (3023M2 accelerometer)
• SV 55 RS 232 interface
• SA 17A external battery unit
• SA 15 power supply unit
• SC 09A AC output (Lemo 1 to BNC) cable
• SA 47 carrying bag (fabric material)
• SA 48 carrying case (waterproof)
SVAN 958A can be supplied with one of the below firmware options. The user can download the new firmware
from the SVANTEK web-site and install it to the instrument.
• SVAN 958A Firmware (supporting RT 60, Crosspectra, Intensity, not supporting modem)
This firmware option is recommended for other than Building or Ground Vibration measurements or if you
don’t use the SV 258 PRO monitoring station.
• SVAN 958A Firmware (supporting modem, not supporting RT 60, Crosspectra, Intensity)
This firmware option is recommended for other than Building or Ground Vibration measurements but when you
use the SV 258 PRO monitoring station.
• SVAN 958AG Building Vibration Firmware for SVAN 958A
This firmware option is recommended for Building or Ground Vibration measurements with or without using the
SV 258AG PRO monitoring station. This firmware option is described in the SV 258AG PRO User Manual.
• SVAN 958A_1 SVAN 958A including 1/1 & 1/3 octave analysis, FFT and Time domain signal recording
• SV 958A_1 1/1 octave analysis option
• SV 958A_2 1/3 octave analysis option
• SV 958A_3 1/1 & 1/3 octave analysis option
• SV 958A_4 FFT analysis option
• SV 958A_5 Reverberation time analysis (RT60) option
• SV 958A_8 Rotation measurement option without Laser Tachometer
• SV 958A_10 Acoustic dosimeter option (microphone not included)
• SV 958A_15 Time domain signal recording option (to the USB Flash Disk, wav format)
• SV 958A_17 Sound Intensity option, FFT base (Probe not included)
• SV 958A_19 Cross-spectra option
Note: The firmware options for the instrument can be purchased at any time as only the introduction
of a special unlock code is required for their activation in a specific instrument. Contact your local
Svantek distributor for further information and costs for these options.
To Next Page
Loading...
