Note: Switch the power off before connecting the instrument to any external device (e.g. a printer
or a Personal Computer).
Note: All reports are printed in the character format using the ASCII set on either A4 or A5 size
paper.
9.1 EDIT THE USER TITLE OF THE REPORT – TITLE
The Title position enables the user to edit the
text added to the file and to the report to be
printed. The text editing is performed in the
special window which is opened by pressing
the <ENTER> key.
9.2 PRINTING THE MEASUREMENT RESULTS – PRINT RESULTS
The Print Results position enables the user to print the report on the attached
printer or to send out the report to a PC using the SvanPC software and the
USB interface.
After pressing the <Enter> key the instrument checks its current state. If the
measurements are running, printing is not possible and the appropriate
message is displayed. If no results were recorded the next message is
displayed.
If a measurement has been already performed and results are available, the
presented message is displayed.
The data are transferred from the instrument to the attached printer, while the
message is displayed. The instrument returns to the Report list after
transferring all data.
The following confirmation question is displayed after the printing, if the
Prompt parameter was selected in the Eject Page position (path: <Menu> /
Report / Options). The user has to answer in this case if the paper in the printer
has to be ejected to the new page.
The message about the time limit is displayed if the printer (or a PC) is not connected or there is any other
reason that it does not receive the data. The instrument waits for the reaction of the user (any key should be
pressed except <Shift> and <Alt>) and after pressing a key it returns to the Report list.
To Next Page
Loading...
