B.13. STRUCTURE OF THE LOGGER FILE CONTAINING TIME-DOMAIN SIGNAL
File header - cf. Tab. B.1.1.
Unit and software specification - cf. Tab. B.1.2.
Parameters and global settings - cf. Tab. B.1.3.
Hardware settings for channels - cf. Tab. B.1.4.
Time-domain header of the file from the logger - cf. Tab. B.1.35.
Trigger settings (cf. Tab. B.1.41, Tab.B.1.42).
Contents of the file from the logger - cf. Tab.B.1.24.
File end marker - cf. Tab. B.1.25.
B.14. STRUCTURE OF THE FILE WITH THE RESULTS OF FFT CROSS-SPECTRUM ANALYSIS
File header - cf. Tab. B.1.1.
Unit and software specification - cf. Tab. B.1.2.
Parameters and global settings - cf. Tab. B.1.3.
Hardware settings for channels - cf. Tab. B.1.4.
Software settings for channels - cf. Tab. B.1.5.
Trigger settings (cf. Tab. B.1.41, Tab.B.1.42).
Vector measurement settings - cf. Tab. B.1.6.
FFT analysis header - cf. Tab.B.1.8.
FFT cross-spectrum settings - cf. Tab.B.1.43.
FFT cross-spectrum results - cf. Tab.B.1.44.
Settings for vibration dose measurement (the presence depends on the MEASURE DOSE and channel filter
settings) - cf. Tab. B.1.9.
Main results - cf. Tab. B.1.10.
RPM results (present if RPM measurement was enabled) - cf. Tab. B.1.34.
SEAT measurements settings (cf. Tab. B.1.36).
Selected statistical levels in channels - cf. Tab. B.1.11.
One-channel FFT analysis results (one for each channel with spectrum analysis enabled) -
cf. Tab.B.1.13.
Header of the statistical analysis in channels (the presence depends on the SAVE STAT. setting) - cf. Tab.
B.1.18.
Results of the statistical analysis in one channel (the presence depends on the SAVE STAT. setting) - cf. Tab.
B.1.19.
File end marker - cf. Tab. B.1.25.
B.15. STRUCTURE OF THE FILE WITH THE RESULTS OF SOUND INTENSITY ANALYSIS
File header - cf. Tab. B.1.1.
Unit and software specification - cf. Tab. B.1.2.
Parameters and global settings - cf. Tab. B.1.3.
Hardware settings for channels - cf. Tab. B.1.4.
Software settings for channels - cf. Tab. B.1.5.
To Next Page
Loading...
