Svantek SVAN 958A - Page 121

121
SVAN 958A User Manual
This function sets usb host port mode to XX, where XX:
0 - OFF
1 - RS232
3 - USB DISC
5 - WAVE RECORDING
#7,UP;
This function returns usb host port mode in the format: #7,UP,XX;
where XX:
0 - OFF
1 - RS232
3 - USB DISC
5 - WAVE RECORDING
#7,UP,XX;
This function sets usb host port mode to XX, where XX:
0 - OFF
1 - RS232
3 - USB DISC
5 - WAVE RECORDING
#7,RC;
This function returns state of remote control mode in the format #7,RC,x; where:
x=0 - disabled
x=1 - enabled
#7,RC,x;
This function sets remote control mode:
x=0 - disabled
x=1 - enabled
#7,CS;
This function performs reset to factory settings. The function returns the following sequence of characters:
#7,CS; after completion of operation
This function is not accepted and not performed while the instrument is in the RUN state.
#7,PO;
This function switches off the instrument:
#7,PI;
This function returns PIC firmware versions
#7,XP;