13.2.4. Security
Description The default admin password for a Universal Robots robot arm controller is
“easybot”. It is a factory setting, configured on all new robots.
WARNING
It is critically important that you change this default admin
password to your own password, to ensure cyber security
of your robot.
As of PolyScope update 5.14 all security settings are set by default to
restrictive (disabled or blocked). (This only applies to new robots and newly
created SD-cards. Otherwise, refer to a guide “Secure setup of UR
cobots”).
If any of the settings are needed to be enabled for your application, you can
easily enable them in the Security screen.
General
Description In the General section of the security settings, you can enable magic files
and configure inbound connections.
A Magic File is a script on a USB drive that executes once it is inserted into
the system. This function is disabled by default to make sure that magic
files are not unknowingly executed on PolyScope.
User Manual 357 UR16e
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
