Heating
In the Start mask, a flashing heater symbol in the
menu bar and the current temperature and status
of the heater are displayed.
Possible actions are:
Heating immediately with LONGPRESS
– Press operating button for longer than 2
seconds.
– Heating mode starts immediately with the last
operating time used. The LED ring lights up red
and the residual heating mode time is displayed.
NOTE!
The function LONGPRESS ON is not available in
ventilation and residual heat mode.
Heating ON with settings
– Press the operating button.
– Select the operating time by turning the
operating button.
– Confirm the operating time by pressing the
operating button.
– Heating mode starts with the set operating time.
The LED ring lights up red, the residual heating
time and the current temperature are displayed.
– Heating mode ends at the end of the set
operating time.
Changing the operating time during heating mode:
- Press the operating button.
- Select and confirm flashing menu
.
- Select and confirm the settings
by turning and
pressing the operating button.
- Set the desired operating time by turning and
press to confirm.
- Heating mode is continued with the set operating
time. The LED ring lights up red and the residual
heating mode time is displayed.
HEATING OFF during heating mode:
- Press the operating button.
- Select and confirm flashing menu
.
- When OFF flashes on the display, press the
operating button again.
- Heating mode is terminated.
NOTE!
LONGPRESS terminates heating mode
immediately and the heater is also switched off.
Start mask, heating
152
Other controls
Operator comfort
To Next Page
Loading...
