Arctic regeneration (optional equipment): Arctic
regeneration mode is used for machines that
operate in extreme cold climate areas where
the machines need to be left running around-
the-clock without operator presence. To use
this optional mode, the parked regeneration
mode should be selected in advance. When
selecting "Enabled" in this menu, the parked
regeneration is started automatically when
needed without any further operator action.
This function will only be active while in parked
mode, regardless of regeneration mode and will
be "Disabled" by default at startup or when
leaving the parked mode. This means that the
regeneration system can remain in an optimal
mode, even after longer periods of idling.
- Disabled
- Enabled
Delayed Eng. Shutdown (optional equipment)
- Off
- On: This function controls the after-cooling of
the engine after the ignition has been turned
off. It secures that the engine is running until it
is sufficiently cooled and then shuts it down.
The time required for the after-cooling is
maximum 2 minutes (exceptional case: just
after regeneration- max. 20 mins). The
remaining time from ignition key has been
turned off to shutdown is shown in the display.
It is possible to abort the after-cooling and shut
down the engine directly by pressing ESC, via
the battery disconnect switch, by raising
control lockout lever or by using any
emergency stop, but it is not recommended.
A message will pop-up at restart if the engine
has been shut down before the after-cooling is
completed. For more information, see page
197
.
V1147262
Engine
Arctic regeneration
Disabled
Arctic regeneration
Disabled
Enabled
Instrument panels
Display unit
47
To Next Page
Loading...
