If a pedal is provided with X1 option (hammer/
shear)
The pedal should be adjusted if it is used for
hammer or shear. Refer to page
95
for details.
Hammer mode
Hammer will work when the pedal is pressed
forward (A).
Shear mode
Shear will work when the pedal is pressed
forward (A) or backward (B).
NOTE!
This instruction can be changed according to the
types of operating lever. For more information about
operating levers, see page
95
.
If control lever with one button (C) is installed
Hammer mode
Hammer will work when button (1) is pressed.
NOTE!
When the hammer/shear function is not activated if
this button is pressed, the power boost will be
activated.
If control lever with four buttons (D) is installed
Hammer mode
Hammer will work when button (2) is pressed.
NOTE!
There will be no response when button (3) is
pressed.
Shear mode
Shear will work when button (2) or (3) is pressed.
If control lever with proportional switch (E) is
installed
Hammer mode
Hammer will work when proportional switch (4) is
moved to left side.
NOTE!
There will be no response when the proportional
switch is moved to right side.
Shear mode
Shear will work when proportional switch (4) is
moved to left or right side.
4) Overload warning button
Overload warning button activates or deactivates
"Overload warning" function. This button is to
84
Instrument panels
Instrument panel, right
To Next Page
Loading...
