7) Engine speed/Work mode control switch
Nine (ten in cases where P-mode is used) different
throttle positions are available through the control
of this switch. Turning this switch, the engine speed
will change incrementally. According to the selected
engine speed, work mode will be set automatically
and setting mode is displayed on the main screen
in the front instrument panel.
North America (normal mode)
Mode
Switc
h step
Engine speed (±40 rpm)
(no load/load)
Remarks
Heavy H 9 2100 / 2000 over
For maximum productivity during
hard digging and trenching
General
G1 8 2000 / 1900 over
For economical operation during
general applications
G2 7 1900 / 1800 over
G3 6 1800 / 1700 over
G4 5 1600 / 1500 over
Fine
F1 4 1500 / -
For Maximum lifting power and
moderate control
F2 3 1400 / -
Idle
I1 2 1100 / -
For low idle, warm-up, and high-
precision operation
I2 1 950 / -
North America (ECO mode)
Mode
Switc
h step
Engine speed (±40 rpm)
(no load/load)
Remarks
Heavy H 9 2100 / 2000 over
For maximum productivity during
hard digging and trenching
General
G1 8 2000 / 1805 over
For economical operation during
general applications
G2 7 1900 / 1710 over
G3 6 1800 / 1615 over
G4 5 1600 / 1425 over
Fine
F1 4 1500 / -
For Maximum lifting power and
moderate control
F2 3 1400 / -
Idle
I1 2 1100 / -
For low idle, warm-up, and high-
precision operation
I2 1 950 / -
86
Instrument panels
Instrument panel, right
To Next Page
Loading...
