Waters 717plus - Page 94

Operating the Autosampler 94
4
Note: To move through the table a screen at a time (10 lines), enter step numbers in
increments of 10. For example, enter 11, 21, 31, and so on.
Inserting a Line
To insert a line:
1. Use the arrow keys to move to a step number where the new line will be inserted.
2. Press Insert Line. The 717plus Autosampler duplicates the previous line, and
renumbers all subsequent lines.
Deleting a Line
1. Use the arrow keys to move to a step number to delete.
2. Press Delete Options, and the Delete Line function key appears.
3. Press Delete Line. The 717plus Autosampler removes the line, and renumbers all
subsequent lines.
Deleting a Table
To delete a table:
1. Press Delete Options, and the Delete Table function key appears.
2. Press Delete Table. After you confirm your intention to clear the table, the
autosampler removes all data on the page.
Options
If you have enabled an option for a step, the option is listed after the Run Time field.
Note: If you have disabled an option, it is not listed for the step.
4.6.1.2 Entering Step Parameters
You must enter a value for each parameter in a step. Parameters you enter are saved in
permanent memory.
Before Programming
Load the required vials in the carousel, noting the carousel positions.
Note: Standard vials and common vials do not have to be loaded in consecutive positions.
Programming
To program: