A
WCDMA Options Version 6.20 259
Appendix A SCPI Command Reference
This appendix describes the commands for test automation using RAPID!, the
General Purpose Interface Bus (GPIB) or a TCP/IP connection. The SCPI commands
are divided into the following subsystems:
– “Signaling operation register group” on page 260
– “Common commands” on page 261
– “SYSTem subsystem” on page 266
– “STATus subsystem” on page 275
– “PROGram subsystem” on page 292
– “FORMat subsystem” on page 295
– “CONFigure subsystem” on page 297
– “CALL subsystem” on page 317
– “MEASure subsystem” on page 322
– “FETCh Subsystem” on page 357
– “CALCulate Subsystem” on page 375
– “RFANalyser subsystem” on page 441
– “RFSPectrum subsystem” on page 445
– “AFGenerator subsystem” on page 447
– “AFANalyser subsystem” on page 451
– “MS Power Supply subsystem” on page 455
To Next Page
Loading...
